Traktor Pro 2.6.0 Full !!LINK!!
Traktor Pro 2.6.0 Full === https://tlniurl.com/2t8o0a
Sorry I didn't see your message before. I don't know if I can help you, but I have x-fader issues too. In my case, when the curve is 100% sharp for scratching, you can still hear the right deck when the fader's all the way left. I fix this by moving the curve slider just off the fully sharp position. It's not a perfect solution but it's the best I could think of.
Mine works fine with 2.6.8. If you have any other mappings imported, try disabling or deleting them first. Remember that there are 2 sets of deck selector buttons on the MC3000, and they can work independently, so it's possible to switch the mixer section to C/D while the transport section remains on A/B. This mapping won't work in a 4-deck setup, only 2 full decks + 2 remix decks. As a last resort, try downloading and importing the latest mapping again, if you haven't already done so.
When you run Traktor, all of the modifiers are set to zero. You can see this if you go to Preferences>Controller Manager. When you hit the Track Select Knob, the modifiers will change to this sequence:1=0 / 2=0 / 3=6 / 4=6 / 5=1 / 6=1 / 7=1 / 8=1 and this sequence will change depending on what you're doing. Features like Smart FX, Smart Buttons, Cue Modes etc will only work if the correct modifiers are selected, so I would recommend pressing TSK. If your controller works fully without pressing TSK, then you might have another mapping loaded at the same time. That's a good point about the FX - I haven't mapped FX controls to Decks C&D, so you didn't miss anything. When I use this mapping, I find that I have SAMP. on permanently on Decks C&D, and control FX from Deck A&B. But for completeness, I think it would be good to have the FX mapped to Decks C&D so that you have the option. Maybe I'll get round to it on the next update... Cheers for the feedback. 2b1af7f3a8